10 Minute Mender Tube Set

Slab repair product: 10 Minute concrete mender (Roadware)

Easy to use for crack and spall repair when fast high strength repairs are needed. The product can be mixed with up to 3 parts of silica sand (sandblasting sand).

Also, consider the 2 Quart 10 Minute Mender kit as no application tool is needed.

Dual 300ml cartridge (22oz) with 2 static mixers/flow restrictor and retaining nut per cartridge Requires Application tool. Also consider 2 quart and 1-gallon kits as no tool needed.

Have on hand scraper, silica sand (sandblasting sand) optionally diamond cup wheel with dust shroud and vacuum.

An ultra-thin product that penetrates deep into the concrete.
A Professional use product. Not recommended for use in enclosed Living areas Unless adequate ventilation is supplied consider E555 
Roadware 10 Minute Concrete Mender, the advanced concrete repair material that is easy to apply and stays in place.
Now you can repair cracks and spalls to a smooth finish in a fraction of the time it takes with ordinary products. Roadware 10 Minute Concrete Mender is a revolutionary new two-part hybrid urethane for repairing concrete. It's nearly water thin for deep penetration and it won't pop out like epoxy because it never gets brittle. Not UV stable and will change color in the sun so coating over is recommended. Use Matchcrete for outside decorative repairs.
  Tube set Instructions   

•  Permanent repair - doesn't pop out
•  Cures in ten minutes for traffic or coating
•  Quick and easy surface preparation - no saw cuts necessary
•  No minimum or maximum depth restrictions
•  Low installed cost vs. alternatives
•  Cures in temperatures down to -20° F
•  Bonds to concrete, masonry, steel & wood
•  Compatible with all floor coatings
•  Moisture tolerant
•  No shrinkage - 6% elongation
•  Excellent chemical resistance
•  Extremely thin - low surface tension
•  Cure stops at 4500 psi
•  Dynamic load transfer
•  May be used as a coating
•  Can be painted - Grinds well
•  Trowelable when mixed with up to 3 parts sand
•  Meets USDA guidelines
• Compatible use with Carbon Fiber Stitches and Staples