Category List

Related Items

Port Low Pressure CORNER Crack Injection

NX2812

Injection corner ports for low-pressure injection repairs in the corner or drilled injection locations. Can be used with all Epoxy and Polyurethane products.

$0.90 USD

InStock

Koster KD2 Blitz Fast Water Stop Powder 33lb Pail

NX2833

Fast Emergency water stop for cracks or holes that are actively leaking through concrete walls. KD2 Blitz powder sets in seconds and is perfect for the setting of ports. Can be applied to wet walls before injection. 33lb pail.

$219.00 USD

InStock

Registered Users

Site security with PCI Compliance Paypal - Visa -Master card AMEX secure online shopping

Registered Users may:
Securely

Item Details

Item Name:

Koster KD2 Blitz Water Stop Powder 2.2lb Box

Name: Koster KD2 Blitz Water Stop Powder 2.2lb Box
Brand: Koster
SKU: NX2830
Price: 22.00 USD
Availability: InStock
Rating: 5 (4 reviews)

Item #:NX2830

Price/ea:

$22.00 USD

InStock

Quantity:

Product Image Gallery:

KOSTER KD 2 Blitz 2.2Lb Box

Fast setting, highly reactive powder for sealing against active leaks

3 - 5 Second set time 20-second cure
Emergency water stop cracks & holes
Outperforms hydraulic cement
Use to set injection ports
Allows for crack injection with wet walls
Considerable Time saved for active leaks

KOSTER KD 2 Blitz by itself is used for the sealing of active leaks. It may also be used for face sealing /closing of cracks prior to the use of injection resins. If used with low-pressure injection systems, KOSTER KD 2 Blitz plays an integral part in the waterproofing of basements from the inside, and manholes, as well as for all other waterproofing against pressurized or non-pressurized water from the positive or negative side.

Most service technicians are familiar with customer calls to actively leaking walls only to inform the customer that it may need to wait until the flow slows or stops. The customer may not call back and you will lose a possible repair job. Many have tried using hydraulic cement just to have it washed away or fail during the injection.
KD2 Blitz Powder solves this by allowing extremely fast set times and when used with our standard corner ports a typical 8 ft crack could be injected and completed in less than one hour.

Using Kd2 Blitz to seal in low-pressure injection ports for polyurethane

Process for active leaking walls.

1. Drill 5/8 inch holes along the leaking crack 1 inch deep every 8 inches.

2. Using corner ports bend back the plastic tabs and pound into drilled holes.
3. With Kd2 Blitz using a putty knife hold powder at bottom of the crack and work your way up the crack to the ports. Water will need to be seeping out if not enough add water through the ports in place, sealing the leaks with KD2 around the ports.
4. After completing to the last port, wet wall and apply some KD2 Blitz powder to the wet wall to build up to help support crack injection pressure.
5. Wait approximately 5 minutes and begin standard low-pressure injection.

Koster KD2 Blitz Water Stop Powder 2.2lb Box

KOSTER KD 2 Blitz 2.2Lb Box

Fast setting, highly reactive powder for sealing against active leaks

Your Canadian Supplier