4 inch high-pressure concrete crack injection mechanical packer.Fits 1/2 in drilled hole usually used with Polyurethane foam.
|
3 inch x 3/8 hammer-in high-pressure concrete crack injection packer.Fits 3/8 in drilled hole usually used with Polyurethane foam.
$1.00 USD $0.78 USD
InStock
|
NextStar 900 20-minute very fast port setting epoxy paste. Ideal for contractors that need to complete the foundation injection in one visit. No waiting around to set ports or sealing overcracks.
|
60-90 min cure time, 901 is a Medium setting port sealing paste epoxy. Used primarily for setting injection ports in place and general sealing over cracks before injection. High strength.
|
3-4 hour slow setting port sealing paste epoxy. Used primarily for bonding injection ports on to concrete and general surface sealing over cracks before injection. Standard in Nextstar Kits. DIY friendly.
$35.00 USD $27.00 USD
InStock
|
45-75 Min fast setting port sealing epoxy paste is used for setting surface ports in place and general sealing over cracks before injection. High strength, Contractor’s preferred choice.
|
20 - 45 min Cure time, short pot life or working time however. Surface epoxy used mainly by contractors for fast repairs or when time is limited. Pro use only, not DIY friendly.
|
Injection ports for low-pressure concrete crack injection. Can be injected directly from a mixer or a feed hose. Use with all epoxy and polyurethane cartridge products.
|
Injection corner ports for low-pressure injection repairs in the corner or drilled injection locations. Can be used with all Epoxy and Polyurethane products.
|
Extra-low profile surface port for low-pressure crack injection. Use where the ports cannot protrude from the surface.Behind or hard to access areas.
|
Pound-in ports for low-pressure concrete crack injection. Used with epoxy and polyurethane resins to deliver material deep into cracks. This is essential for foundation repair and waterproofing projects. DIY and professional use.
|
Auto-Injector capsules for self-injection pressures to 40 psi without special injection tools. Ideal for LV polyurethane foams or ULV slow setting epoxy. Perfect for a DIY one time repair.
|
Nut for attaching static mixers to all epoxy or polyurethane foams in dual tube sets.
|
Choose the right tube mixer for epoxy or polyurethane foam products. Fits standard dual-component cartridges like 102, e555, 10-minute mender, and most brands.
|
Low pressure crack injection feed hose assembly for hard to reach areas or extended injection time. Fits on the end of the standard mixer tube.
|
The standard dual 300x300ml 16oz x 2 cartridge is the standard in the construction industry, Set of 5 with caps, retaining nuts, and pistons. requires a standard mixer to be added.
|
The cross-over back-flow restrictor eliminates cartridge cross contamination between side of a dual cartridge system. This allows unused product to be used later without contamination.
|
Fast Emergency water stop for cracks or holes that are actively leaking. KD2 Blitz powder sets in seconds and is perfect for the setting of ports. Can apply to a wet wall before injection. 2.2 lb 1 Kg box.
|
Fast Emergency water stop for cracks or holes that are actively leaking through concrete walls. KD2 Blitz powder sets in seconds and is perfect for the setting of ports. Can be applied to wet walls before injection. 33lb pail.
|
1-gallon Epoxy set for grouting block wall cracks and repair general structural mortar repair.
|
Category List
