Paste 302 Port Setting Epoxy 600ml Cartridge

Standard Epoxy Paste for Contractor's surface sealing ports/cracks before low-pressure injection.

Dual cartridge  1 hr set time

Emecole 302 1:1 is a high-modulus epoxy gel designed to seal cracks and surface ports onto concrete prior to injection. It can also be used for bonding miscellaneous materials to concrete where a fast cure is required. 302 1: 1 is moisture insensitive and will cure in damp environments.
25 to 60-minute cure

Supplied in dual cartridge tubes
A) Mixed by hand on cardboard and applied directly
B) Setting low pressure surface ports
C) Surface sealing, one cartridge will cover approximately 10ft of crack and ports

AREAS OF APPLICATION

As with any epoxy adhesive, surface preparation is critical. Concrete surfaces should be cleaned by sandblasting, wire brushing, or other mechanical means. All loose or unsound material must be removed. Surfaces should be dry and dust-free to ensure a superior bond. Emecole 302 1:1 will cure in the presence of moisture although application onto wet surfaces is not recommended.

CLEAN UP
Use M.E.K. or Xylene. Clean equipment immediately after use.

SAFETY PRECAUTIONS
This product can cause skin irritation. Always wear protective clothing. Wash contaminated areas with soap and water, never solvent. In case of eye contact, flush with water for 15 minutes; immediately see a physician.