General Epoxy Paste Surface Seal 4 hr cure time
903 1:1 is a high modulus epoxy gel paste designed to anchor Surface Ports and general sealing. It is also ideal for surface sealing of cracks prior to injection. NextStar 903 1: 1 is moisture insensitive and will cure in damp environments.Ideal for use as first-time crack injection applicators.
In addition to normal packaging, 901 1:1 can be supplied in dual-component Tube sets, or 8-oz jars.
Low Odor Sealing Paste
USES:
Anchoring Surface Injection ports
Sealing between the Injection ports before injection
General Surface Sealing
AREAS OF APPLICATION
A perfect Epoxy Paste for setting in place low-pressure injection ports, it has a 4-hour cure time, making it easy for novice users.
As with any epoxy adhesive, surface preparation is critical. Concrete surfaces should be clean and dry. All loose or unsound material must be removed. When patching, the outer perimeter of the spall should be saw-cut or chipped to a near-vertical angle. Surfaces should be dry and dust-free to ensure a superior bond. 903 Paste 1:1 will cure in the presence of moisture, although application to wet surfaces is not recommended.
Mixing
Mixing is accomplished by dispensing smaller amounts onto a disposable surface, such as a paper plate or cardboard. Stir by hand with a putty knife or wooden stick until the mixture reaches a solid grey color. Use immediately after mixing. Mixing by hand is the best method; pre-warming the epoxy will speed up the setup and cure, taking approximately one hour.
CLEAN UP
Use M.E.K. Xylene, or any other solvent. Clean equipment immediately after use.
SAFETY PRECAUTIONS
This product may cause skin irritation. Always wear protective clothing. Wash the contaminated area with soap and water first. Solvents may damage other surfaces, so proceed with caution. In the event of eye contact, flush the affected area with water for 15 minutes and then seek immediate medical attention.
Price is per 600ml Tube set
Item Details
