4 inch high-pressure concrete crack injection mechanical packer.Fits 1/2 in drilled hole usually used with Polyurethane foam.
|
3 inch x 3/8 hammer-in high-pressure concrete crack injection packer.Fits 3/8 in drilled hole usually used with Polyurethane foam.
|
901 is a Medium fast setting port sealing paste epoxy. Used primarily for setting injection ports in place and general sealing over cracks before injection.One-hour cure time.
|
The medium-fast setting port sealing paste Epoxy is used primarily for setting injection ports in place and general sealing over cracks before injection and sets in less than an hour.
|
903 is a Medium two hour setting port sealing paste epoxy. Used primarily for setting injection ports in place and general sealing over cracks before injection.Standard in Nextstar Kits.
$35.00 USD $27.00 USD
InStock
|
Injection ports for low-pressure concrete crack injection. Can be injected directly from a mixer or a feed hose. Use with all epoxy and polyurethane cartridge products.
|
Injection corner ports for low-pressure injection repairs in the corner or drilled injection locations. Can be used with all Epoxy and Polyurethane products.
|
Extra-low profile surface port for low-pressure crack injection. Use where the ports cannot protrude from the surface.Behind or hard to access areas.
|
Auto-Injector capsules for self-injection pressures to 40 psi without special injection tools. Ideal for LV polyurethane foams or ULV slow setting epoxy. Perfect for a DIY one time repair.
|
Nut for attaching static mixers to all epoxy or polyurethane foams in dual tube sets.
|
Static Mixer Nozzles Selector for all of our products. Polyurethane Foam or Epoxy injection products including concrete floor repair chemicals to cartridge systems.
|
Low pressure crack injection feed hose assembly for hard to reach areas or extended injection time. Fits on the end of the standard mixer tube.
|
Seal and Peel port and crack setting paste that can be removed after a crack injection is completed.35 to 45 minute cure time
|
The cross-over back-flow restrictor eliminates cartridge cross contamination between side of a dual cartridge system. This allows unused product to be used later without contamination.
|
Fast Emergency water stop for cracks or holes that are actively leaking. KD2 Blitz powder sets in seconds and is perfect for the setting of ports. Can apply to a wet wall before injection. 2.2 lb 1 Kg box.
|
Fast Emergency water stop for cracks or holes that are actively leaking through concrete walls. KD2 Blitz powder sets in seconds and is perfect for the setting of ports. Can be applied to wet walls before injection. 33lb pail.
|
1-gallon Epoxy set for grouting block wall cracks and repair general structural mortar repair.
|